 |
| The toys are just a smidge too big to go into the decorated mason jars. I will figure out what's causing the holes in the 3D prints and print smaller versions that have the hands on tummies so they fit. |
 |
| Very inspiring rows of mason jars at Look Sharp in Auckland. |
 |
| Printing this sculpt in a standing position, instead of on back, led to better results with the ears, but the fissure-like holes around the neck and shoes are still there. Plus that troublesome spot between the eyes! |
 |
| Printing upright means no nasty rafts to sand off the back. Elsewhere, yes, so it's not without problems. |
|
| Printing on the back of a seated Jellybean. This Jellybean won't sit without falling over so the sculpt needs flattening or it needs a stand to sit in. Fail. |
Little video of the whole presentation, including full run of the animatic.
No comments:
Post a Comment